DENKI OTAKU
チャンネル登録者数 8.91万人
1.4万 回視聴 ・ 716いいね ・ 2024/09/14
Correction: Later I found an NTC thermistor on the back side of the circuit board. It detects overheating and activates protection. I didn't see it at the time of filming.
Supplement: The monitored voltage is of 1 cell individually and all 5 cells combined. The battery doesn't monitor the voltage of the remaining 4 cells individually. This may cause overcharging.
I do not recommend using any batteries other than genuine batteries. The genuine battery I disassembled in the video is sold at overseas branches of Makita.
Warehouse burned down because of a compatible lithium ion battery → • 【閲覧注意】爆発したバッテリーが原因で火災が起こり僕の趣味を全部失いました
The National Institute of Technology and Evaluation (NITE) → https://www.nite.go.jp/jiko/chuikanki...
★ Products used in this video (includes an affiliate link)
Makita genuine battery 18 V https://amzn.to/3TkPogQ
00:00 Introduction
01:37 Disassemble Genuine Battery
04:05 Disassemble Compatible Battery (Company A)
07:45 Disassemble Compatible Battery (Company B)
10:14 Conclusion
■Business inquiries
denkiotaku@ichiken-engineering.com
/ ichiken_make
コメント
関連動画

Ryobi OP4026 95Wh Power Tool Batteries, Disassembly and Cell Harvesting (Battery Hookup)
62,397 回視聴 - 5 年前

Are cheap Makita replacement batteries any good? (Fake Makita Battery Review)
115,172 回視聴 - 4 年前

Ni-Cd to Lithium Battery and Charger Conversion | NiCd / Ni-MH Battery Repair
1,096,532 回視聴 - 3 年前
再生方法の変更
動画のデフォルトの再生方法を設定できます。埋め込みで見れるなら埋め込みで見た方が良いですよ。
現在の再生方法: education
コメントを取得中...
コメントを取得中...